It is a rear sight.
I can defeat a rear sight forward.
But adjustment of top and bottom right and left is not possible.
Because the site that could adjust by separate sale was released by limitation, but did not purchase it; just.

(I am in condition to have woken up half of the sight of a photograph.)

I can divide a barrel by moving a barrel lock according to the true gun.


←it is locking　

it is unlocking→

There is a lock one more to divide a barrel, and there is a potato screw in bottom of a barrel lock lever
It is a screw for fixation not to be able to maintain it only with a lock lever.

I unlock it and am in condition to have divided a barrel.
Such a form can remove a barrel.

It is safety.An upside safety OFF.
 A downside safety OFF.
It is a form to lock direct trigger.

It is bipod.

There is this in a front site basal part, and it is always gone down by a spring, and it is fixed.

It can unfold by I draw out a bipod, and deciphering rock.

And a foot of a bipod can change height into four phases by pulling it.

Storing removes a lock by pushing a button in a by bipod and performs it.

A shoulder rest does a movability.
There can be what wanted to know a feeling of use of the bipod mentioned above in one of this model purchase reasons and the thing that I wanted to know a feeling of use of this shoulder rest.
However, maintenance at a prawn position cannot understand it a little.
A bat plate hits the collarbone for some reason.
Knowing one please teach how I should maintain it.

At first it is a cover part, but there is not a system sending a cartridge at all, and it is a state of a simple cover.

By the way, pressure more than about 0.49Mpa/C�u (5kgf/C�u)was necessary, and a gas hose of a regulator stuck as accessories to operate this model.

A lot of consumption of gas used it by air tank in those days, too.

The operation puts a BB bullet in a field tray and loads it with 60 at the maximum by I connect air, and pulling a steering wheel and pulls trigger afterward.

While it is pushed to air, It pass a duct line under a body, and a BB bullet is sent to a system in a barrel.
A mechanism part is fired by a blow consecutively almost simultaneously by air.

(Because it is memory, I am not sure…)

A shutter of a duct line turns, and a BB bullet is supplied by pulling a charging steering wheel.

A BB bullet is sent into an air duct line with a spring.
A BB bullet is sent by an arrow flow by air.

( Because I was not usable anymore, I tried to cut it as always.)

The place where a pipe of S shape sticks to is the engine district.

A part of an engine part part is mixed up by air and takes out one BB bullet and catches it by packing and fires a BB bullet with air.

When it is mixed up, a barrel is mixed up.

When inside part moves to the left by air pressure, a BB bullet and air are sent, and a BB shot is fired by a green arrow part.

Unfortunately I decided to remove discharge mechanism because there was not the method how this model avoided an object of regulation by the present conditions by a gun and sword method revised in 2006.

At first I remove an engine part.

I may just remove a barrel because it cannot hold a barrel. But because I might do being electromotive in the future, I let I made a thing of dimensions same as an engine part and maintain a barrel.

There is not mechanism and discharge is impossible, but removes an air line in a frame in this because a barrel is not connected.

It is M60 of past days